Terry Oxandale
Skinny Man
I'm getting rid of a lot of my Ford stuff, and currently breaking down the 289 that I've had sitting in the back of the garage for years. I'll list other parts as they come out of the motor later (pistons, lifters, and anything else that would appeal to anyone). Comes from Little Rock, AR, USA
Specs are:
Ultradyne cam, custom grind, solid roller
Advertised int/exh 278/290 242/254 at .050
Lobe center is 112 degrees
Lift is .593 with a .026 lash
This is a high-strung cam. It starts pulling good at about 3300, and hard all the way to 8000 for the 289 displacement, and will work very well with more displacement, and lower RPMs. Has less than 1500 miles on it
$200
Specs are:
Ultradyne cam, custom grind, solid roller
Advertised int/exh 278/290 242/254 at .050
Lobe center is 112 degrees
Lift is .593 with a .026 lash
This is a high-strung cam. It starts pulling good at about 3300, and hard all the way to 8000 for the 289 displacement, and will work very well with more displacement, and lower RPMs. Has less than 1500 miles on it
$200