Hi all
Need to start riveting some ali panels to some round tube (Rear bulkhead panel attached to roll over bar). What is the best way to make sure your rivet hole is in the centre of the of the tube? I was thinking of putting some paint or whatever on the round bar lay the panel on then using the paint mark as my line?
Any suggestions
Need to start riveting some ali panels to some round tube (Rear bulkhead panel attached to roll over bar). What is the best way to make sure your rivet hole is in the centre of the of the tube? I was thinking of putting some paint or whatever on the round bar lay the panel on then using the paint mark as my line?
Any suggestions