plexiglass

Who out there has cut and installed there own clear panels on their car? when you did this ,what process did you use? ,Cutting, drilling and bending. I have some answers of my own ,but was looking for feedback. THE BEST, Kevin

www.cyro.com then check knowledge center

Kevin, unless you have tons of free time, best to just buy the covers and windows and then follow the hints that have been posted on the forum regards to trimming and drilling. The material has held in a frame, heated in an oven and finally pulled down over a form and allowed to cool.
And I thought working with the aluminum was tough.

Brian

plexiglass tools and stuff including drill bits

HERE