Hi guys, I have an inverted ZF (same config as the GT40) in my Lola, and have a leak at the joint where shown. I am pretty confident the leak is at this particular seal.
Im wondering what happens if I were to remove the two nuts holding this small housing on. Will something with critical alignment pop out and fly across the shop floor? Or does the housing come off without drama? Obviously I will drain the transaxle first.
I’m having a tough time finding this gasket so my plan was to clean the old one and coat both sides with RTV.
Advice appreciated!
Im wondering what happens if I were to remove the two nuts holding this small housing on. Will something with critical alignment pop out and fly across the shop floor? Or does the housing come off without drama? Obviously I will drain the transaxle first.
I’m having a tough time finding this gasket so my plan was to clean the old one and coat both sides with RTV.
Advice appreciated!