Search results

Looking for any info on: exact location of coil bracket on firewall, clamps used, etc... Thanks in advance

Came across a couple of magnesium wine glass wheels, 8 X15, same back spacing @ 4" +/-. One has GT40 cast into the front of the wheel, the other MKII along with the size on both, 8.000x15. Any info comments appreciated.

Any pictures showing locations of line routing, catch can(s),type of fittings used, etc... of the original crankcase venting system? I have seen a few shots of vent lines from the rear of the intake manifold. Was that the only vent, must be a fresh air inlet somewhere? Any info appreciated.

On a MKII, where were the wiper fluid nozzles located and the reservoir? Thanks for any pictures and or info.

Anyone have pictures of an original hand brake on a MKII? Any pictures and info appreciated.

Looking for two. Either C6 or D1's (FOMOCO or FORD) lettered. Thanks

Looking for info on the center spindle plugs, specifically the ones on P/1046. They appear to be aluminum, sit proud by about 1/2" off the spindle thread, two small holes on the outside diameter and a washer/nut in the center? Maybe to assist this knock-off install? Any help, pictures...

Period racing pictures of 40's all seem to say FORD or FORD GT along the rockers. Was GT40 ever used? Appears many contemporary builds use GT40.

Noticed in a lot of historic pictures that the spark plug wire loom tab that is spot welded to the valve cover is not located in the middle of the cover but toward the cockpit. This would mean a left and right cover. Were these covers special for GT40s? All the current covers seem to have the...

Looking for the aluminum oval shaped intake pan that surrounds the single Holley carb. Looks similiar to the more retangular Cobra turkey pan.

Trying to attach photos in a private thread but in trying to respond with pictures there is no "Attach files" tab (left side) in my reply block to do so. Is this normal or should the "Attach files" tab always be be showing?

Anyone know if the standard Superformance headers (351engine) will clear the reproduction 302 Gurney Weslake valve covers at rear cylinders 4&8?

Looking for sill mats/carpet for Superformance.

Will the kit supplied Superformance small block headers accommodate big block FE pentroof valve covers and their adapters? Anyone know ? Thanks

Well... after waiting fifty seven years finally got a 40. At age 11, sitting in a 40 in the show room of S&C Ford (San Francisco), I promised I would have one these someday. Have vintage raced my '65 GT350 for years, so know what makes them tick, but a 40 will be a new ball game. Will be asking...

Wanted: Superformance MKII . Any combo considered. Thanks

Just signed up. Cannot seem to post without Poll?