Urs, without reading the thread again... Were there any hard points built into the chassis during construction? Liek any aluminium spigot things where the suspension will load the chassis, or are you putting them in after, as per the photo above, to spread the load? i assume if you just mounted the wishbones direct to the carbon pick up points on the chassis, the carbon would just crack?
Urs, without reading the thread again... Were there any hard points built into the chassis during construction? Liek any aluminium spigot things where the suspension will load the chassis, or are you putting them in after, as per the photo above, to spread the load? i assume if you just mounted the wishbones direct to the carbon pick up points on the chassis, the carbon would just crack?