With P2187 finally on the road after two years and registered in TX as of Friday, the drive out to the truck stop to weigh it for TX DMV made me think about the ride height (forutnately it was a pretty smooth road). Looks to me like the car is sitting a little less than 3.5" off the ground when eyeballing with a ruler, vs the roughly 4.5" the manual indicates. This makes it about 1.5-2" off the ground at the front of the oil pan. Way too low it seems to me.
What is the best process for raising the car a good inch all the way around without screwing up the handling (ie, seems to me I read on one of the threads that adjusting a rear effected the front and visa versa).
Thanx
Mark
What is the best process for raising the car a good inch all the way around without screwing up the handling (ie, seems to me I read on one of the threads that adjusting a rear effected the front and visa versa).
Thanx
Mark