I was wondering if anyone has installed a Slave Cylinder replacement for the throwout bearing, linkages, push type slave etc. My automobile is a 2004 CAV, GT40P/Mark-1B with ford 348 (302) with ZF 5 speed, and a twin disk clutch.
I am going to retro-fit this winter, just looking for good companies that have slave cylinders etc. That you all have worked with.
Or, to maintain authenticity I may elect leave this alone. for fear of spoiling car. If that is the case, have any of you got a good push type slave cylinder provider you could pass my way.
The clutch (and therefore shifting) is awful due to poor design.
I am going to retro-fit this winter, just looking for good companies that have slave cylinders etc. That you all have worked with.
Or, to maintain authenticity I may elect leave this alone. for fear of spoiling car. If that is the case, have any of you got a good push type slave cylinder provider you could pass my way.
The clutch (and therefore shifting) is awful due to poor design.
