Try Kenny Coleman at EDA. He builds lots of american V8s and often 302 strokers so he may have a good standard crank lying around. He built Mark's engine. He will run your engine and set up on the dyno for about £300.
Engine Data Analysis
Engine Data Analysis "Specialist Engine Building & Tuning"
Cheers
Mike
Hi Eddy
Looks good, I am waiting for my chassis from SGT which I think is next in line on the "production line", well on the jig anyway
I think I am number 52 or 53
Cheers
Try Kenny Coleman at EDA. He builds lots of american V8s and often 302 strokers so he may have a good standard crank lying around. He built Mark's engine. He will run your engine and set up on the dyno for about £300.
Engine Data Analysis
Engine Data Analysis "Specialist Engine Building & Tuning"
Cheers
Mike
Should be OK. Kenny will machine the block for the one piece crank seal when he does any other machining. He will also check the crank for any cracks and journal wear. Balance with all parts - pistons ,rods, flywheel and crank damper etc.
Cheers
Mike
He's already rebuilt my transmission - I'll have to look again at the invoice (when I'm feeling brave!) to check the details of what was done.If you are concerned about the UN-1 box look into the Chris Cole conversion to a one piece main shaft. better 1st and second gear and a limited slip.