Had a major win today, put the ole girl back up on the build table yesterday, *so this morning I thought was a good time to double check chassis alignment etc, so using my new beaut laser I plumbed down off both front outer bottom*ball joints and put some masking tape on the floor with an x to mark the spot, then did the same at the rear using the bottom radius rod clevis bolts, next was to transpose the center line of the car to the ground, and then take a reference point across the chassis center and drop that to the ground, then run the tape over it and hope for the best, had to widen*the right *side of the rear by 10mm, then*pleased to say*i'm out diagonally front to rear by the width of the laser beam, approx. 2mm,* so to say i'm pretty happy would be an under statement
good to have a win every now and then aye.
cheers John