running sbc and 930 box, adapted using a complete set-up from Kennedy consisting of adaptor plate, clutch and flywheel. Looks really tight in there - is it normal? I'd prefer to see 5mm or so.... I've only got about 50 thou with the crank at the rearward limit of float.
You'll be good to go guys, this is German precise, specific engineering --if they specify 1/1000 mm as clearance --they mean it --not like that other agricultural "engineered" products that need 1/2" clearance
The only thing of concern would be debri of the roads - that will wedge them selves between the small clearances, ie. use some fine mesh screening over apertures
__________________ The Trans Adapter Man
Last edited by flatchat; 14th March 2010 at 05:06 AM.
very little clutch clearance 930/SBC 
Linear Mode
