Search results

If any of you are having problems with your electronic speedometer(s), after spending $200.00 on proximity sensors I found a fellow who spec'd and fixed my speedo. It works again. Hall effect sensors for speedometers, dah. Bill Hilbornffice:office" /><?xml:namespace prefix = o ns =...

The fellows at quartermaster sold me the wrong flex plate for my 347 ford externally balanced engine. (ok, lets go 1 step further, they do not even know what I am talking about). So....rather than me tearing apart the engine - tranny to install the proper counter balanced flex plate, does one of...

Well, I pretty well rebuilt the car from the ground up. 2004 CAV. 1076 copy. Installed 4.5" clutch, designed and built a new throw out bearing, new bell housing, new 6 and 4 piston Wilwood brakes, new parking brakes, Titon peddal box, all roller bearing suspension pivot points, white exhaust...

Hello CAV brothers and sisters. Stupid question. I am going to insert a direct hydraulic throw out bearing (ref: 2G Motorsports www.gt4d.com, and Tilton Engineering www. tiltonracing.com). I think I have to jank out the engine out and up a bit to do this. Just checking 1st. (the...

Hello. Anyone out thar have brake rotor and caliper upgrades for the CAV? I found a few sites that show Wilwood, but no part numbers. Ill phone Wilwood as well.

If anyone is interested, I may have located era correct tyres for my CAV GT40P-MArk-1B 1969 #1076 copy. Maybe this may save you some time hunting. Dunlop CR 82 530/1360-15, (25.7 O.D. 13.6 section width (sw), 11.2 tread width (tw) 10-13 rim) 525/1050-15, (25.7 O.D. 10.3 section width (sw)...

I was wondering if anyone has installed a Slave Cylinder replacement for the throwout bearing, linkages, push type slave etc. My automobile is a 2004 CAV, GT40P/Mark-1B with ford 348 (302) with ZF 5 speed, and a twin disk clutch. I am going to retro-fit this winter, just looking for good...