As with every project we only see the fun part and never think about the work that gets you to the fun stuff. Since #90 arrived I have been finding places to store the parts and pieces. My diffaculty is finding spots that one, don't piss the wife off. (that means out of her site.) Two, are not in my way when I start to work on the car itself. Three, that will allow me to keep the Porsche garaged next to the 40 as much as possable. (I did buy a new outdoor cover for it, for the occasion when it does have to stay out.) Four, will protect and not distort the body panels.
I do have a 10 x 15 shed next to my garage and have been building a two level shelf large enough to store the front and rear clips one above the other laying flat. (Question, can I store the front clip laying flat but with the bottom side up properly supported so that it is not just resting on the fender curve?) The doors and dash will also be stored here sitting on the back edge. The lower panels and glass go to the spare bedroom and I haven't figured the seats out yet. At no time when dreaming about the car did I once think about these problems.
To all those that offered cheers, thanks for the good wishes.
As for what I purchased, I ordered the following.
RF Rolling Chassis
Panels in stainless steel
Water System (Radiator, Pipes, hoses, fans, etc)
A/C Kit
Fuel Tanks
Body Hinges
Glass kit
Wireing harness
Seats in black leather
Peter