Hello
Just trying to join the engine and gearbox, I have fitted the clutch and used the alignment tool
It was suggested that I should turn the output drive splines to rotate the input shaft so the splines will align, I tried this for about 15mins without success so I pulled the transaxle back and turned the output drive splines and they dont turn the input spline...so
1. if I turn the output drive splines should the input shaft rotate or is there a problem if it doesn't
2. if it doesn't\shouldn't rotate then I guess I should just rotate the engine with the crank shaft pulley till the splines align?
Thanks in advance for any replies
Nobber
Just trying to join the engine and gearbox, I have fitted the clutch and used the alignment tool
It was suggested that I should turn the output drive splines to rotate the input shaft so the splines will align, I tried this for about 15mins without success so I pulled the transaxle back and turned the output drive splines and they dont turn the input spline...so
1. if I turn the output drive splines should the input shaft rotate or is there a problem if it doesn't
2. if it doesn't\shouldn't rotate then I guess I should just rotate the engine with the crank shaft pulley till the splines align?
Thanks in advance for any replies
Nobber