Lynn Larsen
Lynn Larsen
PROBLEM - When the front end was aligned, we were able to get it into spec, BUT the 3/4 rod end is threaded completely into the A-Arm excepting one thread. While I know the rod end cannot turn itself out, the slight amount of tolerance in the thread engagement will become larger over time. Even now, when circumstances are just right, I can hear a pop noise from the rod end shank as it loads/unloads. This is very unnerving to say the least. The bottom A-Arm has a fixed position ball joint, so I really can't easily manipulate the position of the bottom attach point of the upright.
So what would you do? Both short term and long term solutions appreciated!
Thanks,
Lynn
So what would you do? Both short term and long term solutions appreciated!
Thanks,
Lynn