347Stroker's latest activity

  • 3
    347Stroker replied to the thread Blown Slave Cylinder.
    Would I need to have the cylinder fully compressed or could I have it half compressed. That would at least prove the seal. Then to get...
  • 3
    347Stroker replied to the thread Blown Slave Cylinder.
    It’s similar. The cup is a seal that sits in a groove in the piston. A photo on post #47 shows it’s position. It’s looking like I can...
  • 3
    347Stroker replied to the thread Blown Slave Cylinder.
    It its hard to tell from the small hole. Will get the magnifying glasS on it to see if I can work it out. If I shorten the pushrod then...
  • 3
    347Stroker replied to the thread Blown Slave Cylinder.
  • 3
    347Stroker replied to the thread Blown Slave Cylinder.
    Just a very very very basic drawing
    • image.jpg
  • 3
    347Stroker replied to the thread Blown Slave Cylinder.
    I thought the same thing. Surely it Would have to have a substantial amount of pressure to blow past a seal. If it has air in the system...
  • 3
    347Stroker replied to the thread Blown Slave Cylinder.
    So I habe not tried the vacuum bleeding method but I purchased one a the other day. When I have some time I will try it. So should the...
    • E3995B16-96E8-43A4-BF6B-AB706D13AD2F.jpeg
    • F689B90D-BD86-4F82-9825-F28056BF6259.jpeg
  • 3
    347Stroker replied to the thread Blown Slave Cylinder.
    Hey Ian, So I started some investigating, when I pushed the slave into position it has actually pushed the piston the full length back...
  • 3
    347Stroker replied to the thread Blown Slave Cylinder.
    Hey Ian, Thanks for the reply! I'm assuming by the length question your saying that if its not long enough then it's extending ut...
  • 3
    347Stroker reacted to Canuk40's post in the thread Blown Slave Cylinder with Like Like.
    Hi Mitchell, Compare the slave cylinder length in your picture to the length measured from the mounting hole to where the slaves'...
  • 3
    347Stroker replied to the thread Blown Slave Cylinder.
    so in regards to alignment, it basically gives no room for error. it slides into a hole with a perfect fit and is push in to a point...
  • 3
    347Stroker reacted to Canuk40's post in the thread Blown Slave Cylinder with Like Like.
    HI Mitchell, Lots of things happen you wouldn't imagine, until it does! If you look strait into the hole the clutch slave cylinder...
  • 3
    347Stroker replied to the thread Blown Slave Cylinder.
    The starter pinion has been fixed, Im pretty sure it was only an issue as I had it in first gear when I started it and just had the...
  • 3
    347Stroker replied to the thread Blown Slave Cylinder.
    I would imagine the alignment shouldn't change as it was fine before and the slave cylinder slides into the hole so there is no...
  • 3
    347Stroker replied to the thread Blown Slave Cylinder.
    Awesome, will have to have a look. Thanks very much
Top