Alexr59's latest activity

2006 passat rear caliper has an electric actuator, make a mount with a 1/4 steel plate. You can control it with an Arduino and a...

thank you for the advice. and i ordered the parking brake unfortunately. hopefully they have a better version today.

Alex: A good piece of advice I got form Howard and Cam, make sure the steering wheel is centered on the seat, your legs will go a bit...

Thank you Kurt, I believe I have your drawing that I collected a year ago before ordering. where did you manufacture them?

For the factory brake line set up ...see allens videos on youtube.. Lots of info on slc.

Alex, As long as you have two outer brackets that point in the right direction you should be good. The inner brackets you can’t see,

that's what I had in mind, but now the SLC is backward.... So I need to order new support I am going to have a pile of useless parts at...

I can see the dash is not center due to the column position. I might try to temporary fixe it .5 in to see how the position of the seat...

I ended up re-drilling the mount holes for the steering rack about .5" after I got the body/dash in and set the final seat position at...

Most builders angle the seat slightly toward the center. The steering wheel may need to be angled as well. if you want it lined up with...

Yes. But it's an old one with rust, crack boots... I am on backorder for the good one too

I tried to work on driver position yesterday, my steering column came on the car already. When the dash is on, it look like the steering...

Brake lines are finished, happy with the result.

Thank you Hector. I am routing stainless outside also, almost completed. I have seen Joel's video, but it is different in the front...

Alex, Welcome to the forum and good luck with your build, my lines are stainless and routed on the outside, so I don't think my setup is...