CamT's latest activity

  • C
    CamT replied to the thread Ride Height.
    Target ride height with 0.5-1.0” different front to rear, with rear being higher. I have 4” and 4.5” blocks that I slide under my car...
  • C
    https://www.gt40s.com/threads/a-j-s-sl-c-build-thread.45432/page-2 AJ’s build thread, post 35
  • C
    CamT replied to the thread Fuel pump issue.
    If it’s the standard RCR setup it uses a Walbro low pressure pump to feed the swirl pot and a Bosch 044 high pressure pump to feed the...
  • C
    CamT replied to the thread Ken's SLC build thread.
    Sadly on the long list of projects that aren’t getting much attention ... Scott Swartz has some great renders that I’m planning to use...
  • C
    CamT replied to the thread Dan's Build.
    Looks great Dan - epoxy floors? I’m in the process of working on my garage as well - well, I’m paying a pro to do the heavy lifting...
  • C
    CamT replied to the thread Condenser Orientation.
    I'll second what Allan said; I had originally installed it the other way around and when I brought the car down to get my initial charge...
  • C
    CamT reacted to AllanSLC's post in the thread Condenser Orientation with Like Like.
    You will loose efficiency in the ac system because if the number 8 is on the bottom. The system would be trying to force the...
  • C
    I'll confess - many of my fasteners were tightened to the "gootentite" spec. There were only a few fasteners where I used an actual...
  • C
    Tie rod should be secured to the underside of that adapter, as you have it now and consistent with Johan’s, you would have had terrible...
  • C
    CamT reacted to felizguy's post in the thread Restarting my SLC project in West Texas with Like Like.
    Ok , mounting changed, can you guys double check my math? seems awfully tight at 120 ft-lbs, it is a grade 5 bolt 1/2-20 thread. Thank...
  • C
    CamT reacted to felizguy's post in the thread Restarting my SLC project in West Texas with Like Like.
    The most important thing , I got a clean checkup at MD Anderson, lots of poking and scanning but all good, the rest is icing on the cake...
  • C
    CamT reacted to felizguy's post in the thread Restarting my SLC project in West Texas with Like Like.
    One reason for delays was that i decided to go crazy with kilmat everywhere , the thick stuff. prior to installing the a.c heater unit...
  • C
    - Drop gears - An F ton of heat and noise blockers throughout the cabin (I don’t see enough builders going over the top on this subject)...
  • C
    Ask away - shoot me a PM or DM and I'll send you my number. Always helps to have a phone-a-friend when you've been up too long and...
  • C
    Kyle - CF10s are the best option, but I'm biased ;) I second the recommendation that you get a set of cheap, used, take-off, whatever...
Top