Recent content by kiwigt

Mike - on the basis that there's no such thing as a stupid question :laugh: How does an IAC assist in bringing the idle revs down ?. I know they are normally used for managing / increasing rpm off base idle when under load etc. I spoke further with my dyno tuner who confirmed air leakage past...

Re: webbers against injection. Hi Mike - Is the the Accel IAC you use - model 74779k ?. If so can you advise of the wiring connector details please ? Dynaformance replied saying I could have thin throttle blades but to be very careful when installing them :rolleyes: I tried adjusting the...

Re: webbers against injection. Thanks for your advice Mike, I will follow up on your suggestions. The issue with the Dynaformance supplied ECU is that it is Batch Fire, making it unsuitable to attempt to map around what might be inherent problems in the Dynaformance setup, and my dyno tuner...

Hi all. First post here and subscribing to this thread. I own a 1966 Mustang GT fastback with a Roush 342R stroker engine. I just fitted a Dynaformance throttle body setup, and reading these posts I note that I have been down a path that will be familiar to you. First I discovered the...