Recent content by rekab69

Re: SOLD! GTD GT40 Chassis / Bodywork for sale. NOW SOLD. Kept the build table though...!!

Re: GTD GT40 Chassis / Bodywork for sale. Hi Carlos, I have sent the pictures to your email address twice now, I haven't any idea why you are not receiving them.. Any ideas...? Regards David.

Re: GTD GT40 Chassis / Bodywork for sale. Hi, Please feel free to email me at [email protected] for further infomation... Regards, Dave..

Re: GTD GT40 Chassis / Bodywork for sale. Hi Guys, I have a GTD chassis with 6x pin knock off drive hubs, 6x pot Wilwood calipers up front, 4x pot rears, Ali uprights front and rear, spax coil overs (require rebuilding), most of the ali panels already installed have been done to a very high...

Hi All, I'm looking for a pair of good second hand SW 240A pumps, how much are they going to cost? Cheers Dave.

Re: GTD GT40 Chassis / Bodywork for sale. To The top. Px cars / bikes / boats / tractors..... why?

Hi all, Sorry to highjack this thread but it might help someone who is after one. I have an un used one of these for a 351w, if you are looking for one PM me. Cheers Dave

Hello... No air vents/openings.... Best regards D.

Hi, I bought these for my KVA project which has long gone, I believe them to have been commisioned by Ken Attwell, they are showing signs of de laminating which would be covered by a mastic type seal if you were to want to fit them but are more a piece of GT40 history, they have the correct...

Hi Guys, I have a GTD chassis with 6x pin knock off drive hubs, 6x pot Wilwood calipers up front, 4x pot rears, Ali uprights front and rear, spax coil overs (may require rebuilding), most of the ali panels already installed have been done to a very high quality, Full bodywork, side windows...

Re: GTD for sale If you are starting a vote, then my vote goes to Simon! and this isn't just because it's my car he very kindly offered to post for sale on this forum! I have been a member for a few years, I have witnessed back stabbing from manufacturers, snipping between forum members...

Thanks Chris, have a Merry Christmas. Dave.

Just bringing my post to the top again, any advice on obtaining these parts gratefully accepted... Merry Christmas...

Hi, I require the parts in the pictures (thanks Russ) below, part numbers would be a great help too. Worldwide no problem.. Thanks Dave..

Hi Simon, I have an old pair of "glass" side windows from a KVA... bought them a few years back of off Rob.. the stuff you buy eh? Cheers Dave..