Search results

You may want to fabricate rock shields

I ordered one about a month ago. No ETA yet

Thanks Cam!

Cam how wide of a flange did you leave for the engine cover louvers?

I’m currently waiting for a set of engine cover louvers for my SLC. What width flange do you cut the opening when installing the louvers?

I like the orange and the detail work on the front and splitter. Very nice!

I have noticed that a few people have wrestled with the steering column/ seat/ pedal alignment issues. Just a point to ponder Many mass manufactured cars as well as a lot of the race cars I have been in do not line up as common sense would assume. You just adjust and don't even notice it. Take a...

Very interesting ! Cant wait to see what your cooking up :D

Hector for critical bolts you may want to look into Nordloc washers. I’ve been wrenching for 50 years and am genuinely impressed by how effective they are. One spot that was always a sore point on the Dirt late model I was crew chief for was the header bolts. These were the only things that...

I like how Mason threw in the ground reflection. How about topping it off with gold wheels?

I sent you a PM

I did not get a nylon spacer

Back in 2009 I attended a World Class Driving 200mph Extreme challenge in Uvalde Texas. The event was at the Continental/General tire tire test track. If you Google earth Uvalde Texas you'll notice a large oval outside of town. It is an eight mile concrete oval surrounded by various other tire...

Del, where did you get the front hood hinges?

I’m also at this point and was wondering about the cutouts. I’m going to make similar plates but because I have power openers the lower portions are cut out. In order to strengthen the door in that area I’m going to fiberglass the inner section filling the void and use that to bond the plates in...

Thanks Howard. I already have a string set up and a straight edge for under the car to square the set up. I purchased a digital angle meter that is very helpful. I was able to at least get the basic alignment close. I’ll spend this weekend fine tuning it. (At least when I’m not watching the...

Good luck with the new job!

I know what I’m doing this weekend!

Thanks Howard. I will check it this way. My question is about what size upper and lower spacers did you end up with. I am puzzled at the way the car was shipped with seemingly custom made spacers that when the rear tie rod was compared to the lower control arm angle was way off. Does the about...

I recently aligned my car including successfully setting the frt bump steer. Using a 1 inch steel spacer as I have read in some posts got me within .05 of a degree in the frt. The rear is a different story. My car does have the the double shear set up. The car came with a longer lower spacer and...