Search results

Hello Looking for a engine & Transmission cradle preferably on wheels here in the UK most of the stands I have seen are for just engines and I dont really want to split the transmission again ;-) Thanks Neville

Ok so in my excitement I ordered two of these but when they arrived I realised that the gap between the pipes was far too big (I should have checked first) anyway I might still be able to use them I'm thinking to cut out the middle bit with the bolt then make a bracket to go around the outside...

Brilliant, thank you just ordered 2, thanks

Thanks Andy

Any thoughts on this please

Thanks for all the replies and suggestions, I bottled it at the thought of making my own + the hassle so I bought these in the end LiftMaster 2X Car Wheel Dolly Premium Ball Bearings Skate Furniture Mover : Amazon.co.uk: Business, Industry & Science £108 for 4 with brakes but thanks anyway

Four Vehicle Positioning Wheel Dollies - 450kg Per Dolly (sgs-engineering.com) these ones? thanks

True just wondered if anyone else had done this ;-)

Ok thanks for the replies I'll investigate making some thanks

Looking at the fan brackets are they pop rivetted into the actual radiator...is that ok to do, thanks

Hello any recommendations for wheel dollies in the UK the ones at Machine Mart and SGS dont seem to accommodate 12 in tyres, thank you

This looked promising but cant find one anywhere

Hello I need to install my condenser Rad to the front of my Radiator I'm not too keen to thread plastic rods through the radiator to secure it and I doubt I can fabricate anything that will do the job and look ok so any suggestions on some ready made brackets Ideally I would like a plate for the...

Only moving while I'm test fitting ;-) thanks

thank you both

Hello I need to run several different pipes through some of the bulkheads does anyone know of a UK supplier for some thing a stub flange but rubber or plastic that I can just push fit into the hole to protect the pipe I tried some u channel edging trim but its not very secure and keeps coming...

Sorted in gear and turn both outputs aligned the splines in it goes, thanks Frank, thankfully I hadnt done that

Hello Mike, ok I'll try that tomorrow when I open up my garage, thanks

Thanks for the replies, yes I tried to put it in gear no difference still didnt turn, and yes I tried the input shaft into the clutch plate all ok I am concerned now that there could be something wrong if the input shaft should turn when I turn the output shafts...

Hello Just trying to join the engine and gearbox, I have fitted the clutch and used the alignment tool It was suggested that I should turn the output drive splines to rotate the input shaft so the splines will align, I tried this for about 15mins without success so I pulled the transaxle back...