Search results

Have you given any thought on your throttle cable route yet? Im tossed up if i want it run through the inner tunnel and pull from front red)or make a lever that brings it to behind pedal and pull (blue)

the section in red will be permanently mounted for spider.the section in blue will be removable for full access to fusebox,relays etc. going to put a seal around the removable panel that when it’s mounted seal compresses for watertight fit. thats though with comp,really limits you.can even mount...

Im making a removable panel in the top aluminum cover for access to fuse block&relays. Will be water tight. I wanted as far out of way as possible to allow more room for heat/defrost&ac ductwork etc

Nothing like starting mon morning at work making more under dash harness labels lol

3/4 hubcentric adapters in front,1/4 spacer rear. SLC56-front calipers DPC56-rear calipers

So much better lol. I ran the wires through f&r rails existing holes.

OR maybe part of the ejecto seato lol

Lol was going in house to replace one and got side tracked,decided to do wiring instead

Up to the fun part, where it all ties in .who dont like some spaghetti .before i pulled dash back out I use the blue tape just as a reference so i know where to bring the individual harnesses out.

Exactly,what a difference in strength and finished it off nice.

Moving along on the wiring,once I put aluminum panels back on I can Mount harness clamps and get rid of tie straps

That just looks like a headache lol

https://www.amazon.com/gp/product/B07DNPL2VC/ref=ppx_yo_dt_b_search_asin_image?ie=UTF8&psc=1

This is lift lights only, garage lights off. I bought on amazon. Best 50 spent lol

Your garage looks way to clean lol. You need the led lights on your lift, was the best thing i did on mine. Ill post a pic later when im in garage. Lights up ghe whole undercarriage without blinding

Made the front floor panel tonight, completely stiffened the whole front up.

2 builds going at once wow you must have a lot of patience lol. I just finished my cobra build,going for paint feb/March.I just put on the stainless side pipes,this old pic

That would be a good thread starter lol

They have any size&width you need. They did a set for my cobra 17x8.5 front 18x12.5 rear

Yes, Chris supplied the wheel package. If your getting your own wheels, Bob at vintage wheel is great to deal with aswell. I bought quite a few wheel packages from him for my cobra. If i couldnt get the 18” with chris i was going to use vintage again.