Search results

One of the recommendations heard often is to wrap the headers with fiberglass tape. My experience is that it greatly accelerates rusting.

Cera-Kote is also a similar process.

As long as we are on old, jokes... What is purple and almost ruled the world? Alexander The Grape.

If the surface of a piece of aluminum gets some scars, don't worry- just go over it with an orbital sander using 600 grit abrasive and a little water for lubricant. This leaves a nice pattern and it is also good preparation for applying primer if you choose.

Edges of sheet metal present sharp edges that can cut skin, chafe wires and fluid lines. I have found an easy way to protect these edges from doing damage and also presenting an attractive appearance. A push-on grommet made by Spring- Fast works perfectly for this application. I'll attach a...

You might contact Kennedy Engineered Products (KEP) and see what they have that will mate your engine to transaxle.

FYI- "...schedule 80 x 7/8 tube..." "Schedule 80 is usually used to specify pipe sizes; tubing is usually specified by its outside diameter and wall thickness in the US. NZ may have a different convention.

If you have access to a 4" to 6" belt sander I think you would find that it works better than the disc type. Whichever you use, see if you can find 3M "Cubitron" abrasive. It is an oriented ceramic that has very sharp grains and wears very slowly. I found that it is the absolute best for metal...

That image looks like CGI to me.

This gear set fits the Porsche '89 Turbo G50, G50-50, & G50-52 transaxles. Please verify this for yourself. :) This is a high speed cruising ratio for 5th gear. The gears are Porsche with 31:41 teeth. Unused. $500 + shipping.

Lift & turn latch made by Southco. Part number 62-10-402-20. These latches are adjustable to fit a very wide range of panels. These mount flush to the surface in a rectangular hole. $20/pair + shipping.

Porsche Clutch throwout bearing for G50 transaxle. This is the new 32mm size. Porsche part number 950.116.080.08. Unused. Includes a flywheel needle bearing insert for a Chevrolet small block or KEP flywheel. $200 + shipping. I'll throw in a replaced (junk) G50 clutch release shaft and...

"Ford GT" instead of "Ford GT40"?

https://lsrlive.com/live-stream/ Live streaming begins in the morning at about 0730 MST.

Of course there is always some degree of risk but don't make it inevitable.:rolleyes::rolleyes:

Begins tomorrow morning!

If it were my project, I would design my own PID controller & PWM driver. I haven't followed the market as to what is available but a good system will be dependent on the sensor temperature/resistance slope and the thermal time constant of the coolant system. It is an engineering challenge...:)

This looks like a nice electric water pump but the lookup table controller is not the way I would do it (it's the design engineer in me). A pot that sets a desired coolant temperature, a coolant temperature sensor, and a PID controller with a PWM output would be my choice, Set the pot to the...

Thank you, Dave.

"...The band played "Eternal Father Strong to Save...", also known as the Navy Hymn. I had that played for my late wife Ella, as she had been a Navy WAVE.