Search results

When I have finished the wiring this thing it will glow...and there's an 8 ohm speaker, too, for sound FX. Video to follow.

A lot of UK builders use a polyurethane product such as Sikaflex 221. https://gbr.sika.com/en/industry/transportation/caravan-and-motorhome/interior-and-exteriorsealing/sikaflex-221.html

Fantastic, thanks!

If you can't adjust the inner end of the lower wishbone, could you adjust the two outer Rose / heim joints? Or, do as you say - remove the bolt retaining the lower inner rose joint and make your best guess at the adjustment needed then re-assemble. You might then be in the ball-park, and...

Could you clamp your damaged panel to some new aluminium sheet and drill through, or transfer marks?

@Shed Racing @Andy318is If you decide on twin rear light setups, I'd be interested to hear what height the lower lights end up at. I'm pretty sure it's a minimum of 350mm for UK IVA test (though you car has already passed, I guess, Andy?).

Depends which car you have, but I would have thought that the upper link would be made with RH / LH rod ends so that you can slacken the two lock nuts, rotate the upper link and this will move the top of the upright in/out to adjust camber. You'll then need to readjust toe and caster with the...

To commemorate, I've been busy in the workshop...with some left-over stainless water pipes from the GT40, a lump of aluminium round bar, bit of black Acetal round bar, some plastic strips and multicoloured LED tape:- Inner chassis (to hold control circuitry, battery, charge port...

Do you have contact details for Stanley Knife? Asking for a friend....

Hi Nick A long time ago, when we were fitting DCOEs to Mini and Escort manifolds, we were told (and found out for ourselves it was true) that Weber flanges were easily distorted if rigid fasteners were used, and then they would leak air for evermore. The only thing which worked were the Misab...

Track:- As for comfort on the road....hmmm!!

First sill installed... And then fixed in place - I used countersunk rivets on this panel Cover plate is bolted into csk Rivnuts. Same, but with gear change rod shift cover in place.

Hi Devin You're located in Ontario, right? Is this something you're selling? Cheers Eddy

That's exactly what Bill Gates and George Soros have programmed you into believing....

You mean...do I have two spare? Or that you have two spare?

Nine holes is correct; here's a Gelscoe magnesium cap:- But hard to believe that Broadley (or FAV) would have been designing in millimetres...? Wonder if it's 9 x 6" on originals...

Hi Neil I think that suggestion is intended for Andrew's Tornado project; he has his own thread... https://www.gt40s.com/threads/tornado-ts40-evolution.54226/#post-558345 My tanks are Southern GT and are bolted-in using their own flanges / brackets. Cheers, Eddy

Hi Andy I see you have had the same problem as me...lack of rigidity!* I clamped a couple of hefty alloy blocks either side of the upper & lower jaws to reduce the throat of the roller to the minimum where I could still fit the workpiece into place - this helped a lot. Prior to that, the upper...

Friday was bracket day... The Malpassi regulators will be fed by two of these Carter P4600 pumps...one each side, as near to being level with the tank outlets as I could mount them. Gauze filter to catch any swarf or crud, then the pumps (one each side) will feed a...

The (relatively) cheap bead rolling tools are hard to use - one hand turning the handle means one hand to guide the workpiece, with the inevitable wonky lines. To get round this while still working single-handed I made up some nylon guide pulleys and screwed them to some MDF sheet, as shown...