Search results

You likely have some debris in the needle/seat. Just pull the needle/seat assembly out, blow it out well, and then re-set your float level.

Full set of gauges, new in the box. GPS Speedometer - MPH, Electronic Tachometer, Oil temperature, Oil pressure, Water temperature, Voltage, 2 - Fuel level gauges. 8 gauges with installation hardware and sensors. $1200 US or best offer + domestic or international shipping. Located...

Period Correct have a few

RCR body fit

Try Taylor, They did my Mk l half shaft to spec for under $600. https://www.taylor-race.com/

Possibly field wire shorted to ground or battery short.

Raceline MK I kits

Sorry about that. I spaced that there is a reducer and then the 3/8” temp sensor.

3/8” ntp

Wench = winch. Or not….

Look like Vitaloni Californian

Not sure about removal as mine was already installed. The bracket for the in/out bolts to the rear of the case using the two lowest bolts

The shift rod assembly is removed exposing the internal shift rod. The cable bracket mounts to the rod assembly holes and the Paul and bellcrank mount to the rod. The other cable bracket mounts across the rear of the trans as in you pics. I’ll post a couple pics later today. Hope it makes...

I ran hard lines from the condenser and bent them over the top of the radiator. No need to cut the side plate. Rubber lines in the spine. I would have run them in the spine in hindsight as it saves space and allow you to crimp your fitting on the workbench…

I used these…. Tank Bushings

Neither were part of my system I received two months ago. Multiple sources, vintage, classic air, old air, Amazon, etc.

Mine is 10 spline x 1-9/64"

Here is the Washington process for registering this type of vehicle. WA kit vehicle registration Contact Superformance to see if the can provide a certificate of origin. Park Place would also be an option for a valuation and clarification letter. Most license offices aren’t familiar with...

Check with bill hough <[email protected]>