Search results

(and if possible weight of the wheels, should be light for that size in magnesium)

No rush. Most likely 14" wide and six pin drive.......

OP, What is/are the width of the rear wheels and offset? (from rear mounting flange to outer lip of wheels) Six pin drive or five pin, and pin hole spacing?? Thanks, Scott

As already mentioned the cost of an SPF roller is roughly 2.5x what a deluxe RCR kit runs. By the time you get the RCR to the same level of fit/finish completion they are much closer in cost depending on WHO is doing the work. If you plan on doing any serious track time with the gt40 I would...

Panel is 18x12.....

Takis, I would stay away from the MT Sportsmans for a road car. I bought a set when I first,"Gulfed" the rear clip for set-up and rim/tire sizing. They looked like AVONs, were out of round, and would have had to have been shaved. Even then I probably would have never gotten rid of all the...

Here is a pic........during a quick alignment.

M&H makes a 390 45/15 drag radial that is dot certified......... (it is a little taller like 33, I run it on my RCR GT40)

Fred, general rule of thumb is replace at 5 years.There is supposed to be another set of numbers stating when tire was made......ex 2010 would mean 20thwk of 2010. S

They look about right to me! ;0)

OP, Best bet is to call/email Bill or Fran. Chris Arden may have something for you right now. (get all the parts from one source) Trying to marry different parts together is a real job if you are not a professional fiberglass repair guy as mentioned in a previous thread. Scott

OP, Randy, You wont be able to fit the front or rear clips easily either as they wont match up between replicas!! A HOT MESS to say the least....... I would recc. you buy the body all together from one source. (unless of course you or a GOOD friend are great at repairing fiberglass/corvette/boat...

JP, You may want to try putting the back of your seat all the way up against the bulkhead. I dont have a picture of my seat handy, but it hinges in the middle where the top and bottom half meet so you can adjust the slope. I am 6'2" and lay back in my seat and clear with about an inch to spare...

OP, sent you a PM. Scott

Porsche 930 trans or Rbt........

Dwight, I run about 25-26psi on all four corners while on the street with DRs. (you can mark a couple of lines across the tire treads and check the wear pattern after a short drive) . Adjust as necc. S

Welcome Danny and George! A friend of mine in Lake Helen has an up and running Active Power chassis. I am in Daytona beach-side. Where are you located Danny? Congrats to you both, S

More humor for the 4th!! S

Tom, Was nice to see you again and see all the mods to your 40! Hopefully next time we can get them on the track and wring them out a little...... Mike thanks for the pics/video and bringing your SPF out. Was nice to meet you and hope you decide to keep your car. Now lets plan a trip to...

OP, The Superformance wide body rear clip looks a LOT different than the wide body gulf cars I checked out a couple of years ago at the Amelia Island Concours. (the rear clips looked more like flairs were added to standard width bodies, rather than widening the rear deck and changing the flair...