Search results

update of this week end Installation of radiator with grommets. There is a little flex but not too much (hopefully enough). Bolt have nylon nuts and are not torqued. I finally have the driver seat in place. Steering wheel as left as possible without looking off with the dash, interior seat...

I have the RCR shifter. I will modify the console for sure, and I am planning to let the beautiful peace of billet showing the mecanism!

Thanks all for all the advices. I think I can deal with a small offset, but as it was, it is over 1.25" offset and it doesn't look or feel good. First thing I did was to move the steering 5/16" on the left. if I do more, it will not be centered with the dash board. (I also center the dash)...

do you have RCR bracket laser cut reversed? I don't see how I can use these brackets without reversing them, it put the seat way too far from the center

let see what i get when i receive my emergency brake from RCR. if not good, that might be going this direction.

thank you for the advice. and i ordered the parking brake unfortunately. hopefully they have a better version today.

Thank you Kurt, I believe I have your drawing that I collected a year ago before ordering. where did you manufacture them?

that's what I had in mind, but now the SLC is backward.... So I need to order new support I am going to have a pile of useless parts at the end of this project with all the parts provided not working :D

I can see the dash is not center due to the column position. I might try to temporary fixe it .5 in to see how the position of the seat is. Anyway I don't know how the SLC seat mount can be used on the center console side, way too big.

Yes. But it's an old one with rust, crack boots... I am on backorder for the good one too

I tried to work on driver position yesterday, my steering column came on the car already. When the dash is on, it look like the steering column hold the dash .5" to the passenger side. What is making it harder to have the seat aligned with the steering wheel that is .5" on the wrong side. Not...

Brake lines are finished, happy with the result.

Thank you Hector. I am routing stainless outside also, almost completed. I have seen Joel's video, but it is different in the front end. Alan's video also has the car was without extended footbox. I have check Cam build also! Having the car almost ready to drive has to be very exciting ...

Thank you. I was going that way, now I know it's going to work !

Thank you. I saw your build but as you said, you run them outside. It's complicated, nobody has the same design . And a lot of pictures don't have the extended footbox. I will run them inside, it's just a pain to make and install lines inside the foot area.... (including valve, T, pressure sensor)

Anybody have pictures of the brake line on the front? Flexible routing...

14 months

I would love it! I will give you my number in PM

thank you Joel. waiting for my delivery and I will decide what to do!

thank you Joel. Good to hear, so I am not the only one with that problem. I ordered a roll of stainless line and will run all new lines (even at the front the bends are not following the body as much as I would like). For the front line, I will also run new ones, so I will not worry about them...