welcome to GT40s.com! If you've never posted on the forum maybe give it a go by introducing yourself in the Introduce Yourself Here forum. Also, think about becoming a Forum Supporter at GT40s.com. Becoming a supporter will allow you more PM space, an avatar, and the money is used to keep GT40s.com running.
Enjoy the forum!
Welcome to the GT40s.com, the World’s Largest GT40 resource.
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, view pictures, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, Join Our Community Today!
Why not start with your first post today and become an active part of GT40s.com now! And, if you find you enjoy GT40s.com think about becoming a Forum Supporter.
GT40 Parts For SaleIndividuals - Advertise your parts for free!
Dear Members.
I have an Inlet Manifold that I would like to sell to a good home rather than sell it on EBAY.
The Manifold is for a 427 side oiler. I have owned it since 1969. it came with a mountain of parts that I bought from S&S in Phoenix Arizona in the late 60s early 70s.
I am moving county. So I am going to sell all the engines and parts I have collected over the past 37 years.
photos below. Please feel free to contact me about this manifold.
Ron,
These photos are of a Holden 308 Manifold going by the port spacing/bolt pattern & the relief for the dist at one end in the valley area. If you bought them in the USA then they probably came from the Pontiac motor that the Holden V8 was derived from.
Re: Webber IDA Inlet Manifold 
Linear Mode
