I put the engine on the dyno last week to set up the fuel maps in the Haltec ECU. Results were pretty much as expected. 380 + ft-lbs torque from 3500 to 5600 rpm, peak of 410 ft-lb at 5000 rpm.
HP was 257 at 3500, peak of 410 at 5500.
This is on the smaller open chambered Cleveland 2V heads.
Should make a pretty fun street engine. Another piece of the puzzle completed!
For all the data on the engine go to
http://www.network54.com/Hide/Forum/message?forumid=119419&messageid=1016333393
Dave
HP was 257 at 3500, peak of 410 at 5500.
This is on the smaller open chambered Cleveland 2V heads.
Should make a pretty fun street engine. Another piece of the puzzle completed!
For all the data on the engine go to
http://www.network54.com/Hide/Forum/message?forumid=119419&messageid=1016333393
Dave