I have what I think is probably a simple problem that I thought some of you smart folks here might be able to help me with. I recently bought some standard weight plates for my home gym however the centre hole for these plates where the bar goes in is just a little bit too small. The hole is supposed to be 28mm but my new plates are probably closer to 27mm. I have tried filing the plates out with a hand file but as the plates are anywhere up to an inch thick of solid metal, even to make a mm here or there difference takes bloody ages. What I am after is a mechanical solution where some sort of machine can be used to either drill or file out the holes that little bit extra so that they slide easily onto the bar. Any suggestions would be greatly appreciated.
Regards
Jack
Regards
Jack