I am using a Meziere pump up front in my car, and I have been trying to be sure I have done things OK, so I think I will ask here:
(1) I have the pump up front, low pressure side of the radiator, and I have an in-line Nascar style thermostat that I put back by the engine thinking it would open faster. It has a -6 AN bypass line that is 6 feet long and comes through the center tunnel to dump in right behind the pump.
I am thinking about moving the thermostat to the front of the car. If I do that, I will have a -6AN bypass line that is about 1 foot instead, but the thermostat will be 6 feet from the engine (doesn't seem to bother anyone here).
Meziere had just said to run it without a thermostat.
(2) I am running a bleed line from the upper corner of the radiator back to the tank. I already have a similar bleed line from the top of the motor to the tank. Can I use a T-fitting at the tank, so that these will essentially connect as they go into the tank (easier packaging in a tight space) or do they have to go into separate inlets on the tank? I am using Meziere expansion and recovery tanks.
(3) Lastly, as I mentioned, Meziere tanks. Both are 28 oz. Is that going to be enough volume for this cooling system?
Thanks a bunch gentlemen.