Recent content by heralue

I didn't write complete setup, I have a EWP150 placed at front with radiator and use no thermostat.

Since my engine is tilted forward I must add extra vent lines from intake. 1. Front of radiator house 2. Not used 3. Vent line with AN4 4. Impossible to use because of headers 5. Sender to Water temperature. Will this work or sould I add extra vent line from 2,3 or 5 ?

I could not get the car finished before winter....

The position of damper for rear clip may be changed in the future. I will not change the opening angle, now it is possible to remove engine with transaxle without removing rear clip.

I will get the dimension for you Bill this evening. It was necessary to lift out the engine before I could mount the headers.:furious: Start up is getting closer :thumbsup:

The 347 and 01e in place !

I've done like this

Back from paint shop!

Working with aluminium panels.

Final assembly has started

Heading for LMC 2016. Wimbledon white.

Great !

In another thread were was a van with stripes similar to GT40. This is my Ford Tri-Star E-350 with 7,3 l Powerstroke Turbodiesel V8......:thumbsup:

Now its time to start final assembly.