Jkviper's latest activity

With all of the bits and pieces removed from the chassis, I flipped it over and sanded the bottom and what may be considered wheel wells...

I figured I could store the body on my 4 post lift & lift it up out of the way. Here is what it looks like: Fran said to hang to doors...

First task to get done is disassembly. This thing is stuffed full of parts. Where in the heck am I going to keep all of this stuff...

Well, here we go. I order my RCR40 on February 2, 2023. In late March 2024 I received the email from RCR that my car will be ready for...

Got the SL-C started and took it for a short drive up the street. Torque is amazing !! Brake setup similar to Joels, with GM booster...

Sunday, April 21st COTA with Chin Motorsports. The weather was cold in the morning with the air temp at about 60F@ 8 am and the wind was...

Hector, very happy to see you complete the build. It’s always a lot of fun exchanging spy pics and kidding around about our progress or...

I just looked at the beginning of this thread, was started on May 19th, 2020. So I need to have the car at a a 98% or better finish by...

Next was the rear clam window and vents, the vents were straight forward , I ordered the standard ones, the finish looks standard but...

I cut a hole on the rear clam for the clam to clear the transmission when fully opened , that meant the rear hinge had to be split in...

update of this week end Installation of radiator with grommets. There is a little flex but not too much (hopefully enough). Bolt have...

This weekend I finally redid my alignment after putting it off way too long. I did an initial rough alignment back before I had the body...

Thanks Joel! Yea I'm glad I took the approach of driving it a bit (have 1900 miles on it prior to paint) just because it helped to...

Looks fantastic Mark. Congrats! Wondering how painting around the windshield went. Most builders have painted the body then installed...