Recent content by Louis

Hi Vinny! What starter did you go with? Thanks, Louis

Thank you William! Much appreciated!! Louis

Hello Everyone! My build will be using 351W stroked to 427 with a ZF transaxle that Ron McCall is rebuilding. The chassis is RCR. I'm looking at both Quicktime and Kennedy Eng. for the bellhousing. The car is being setup for 90% street and some track time. Kennedy Eng. is asking if I will...

Hi Vinny! What gearbox did you decide on that will go with the Prestige Motor? I'm getting ready to order a Prestige 427 as well. Thank you! Louis

Thank you Brian!

Hi All, With Craft Performance no longer available and Prestige Motorsports engines requiring the CVF pulleys to fit in the RCR chassis and Roush not responding to phone calls. What engine builders are still out there? Appreciate it! Louis

Hi Rod! Attached are a few pictures. The first pic shows the fabricated lip on the spider and the fabricated dash extension. That dash extension slips into the lip and supports the front of the dash. On the 3rd picture you see an extension on the side of the dash. I will make a piece to fit...

Hi Jim! Has anyone sent you pictures or explanations? I have the roll cage as well and cut my dash to be removed with the roll cage in place. I also fiberglassed a lip on the spider and glassed an extension on the dash that slips in the lip. This way the front of the dash is supported. I...

Hi All! It's been a few years but I'm making slow progress on the MKII. I do have a question about the Center Scoop on the rear deck. Two of the attached pictures show the the scoop of the original P1015 at the Carroll Shelby Museum and mine labeled LW1015. Does anyone know why the scoop...

Thank you all for the replies and schematic. Now I know it's a dimmer. Louis

Hi All, This attached picture of the original dash in the P1015 has a switch between the toggle switches. Does anyone know what this switch does? Thank you! Louis RCR GT40 MKII

Hi Morten! Good to hear from you. The RCR specs for caster are 5-8 degrees. Mine was set to 6deg. The solution will come. Louis

Advice from Bill at RCR was to double-check my suspension alignment before cutting anymore on the rocker panels. Always wanted to make aluminum spacers to replace the shim washers anyway so I'm doing that. Before I took the suspension back down the wheelbase = 94.5" Close to 95 specified by...