Recent content by pxr5

Steel tube race car chassis, came from TWR. Looks like it was designed for a solid rear axle, It was being converted to IRS, by TWR.The top tubes are only tacked on, the rest of the chassis is all welded & sound. Had this listed on e bay, but removed it as the bidding was only at £19, with...

I've listed this front engine chassis, it was a development project that came from TWR in England. Take a look on e bay no' 320918898173 Open to offers! It's very nice!

Not a GT 40 question, sorry!, but I've picked up a front engined race car chassis, very nice, it has the makers name ''R+D Race To Uk''. Has any one heard/know the makers? (I'll post some pic's later ) Thanks

I've fixed this, thanks

Hi I need to use a spacer behind the flywheel ( Not ideal I know), only need to be by 1/4" to allow the driven plate full contact on the splines. I could possibly get away with standard ARP jobbies, checked Summit & have Googled - but no joy, any suggestions ? thanks Stock is 7/16 X 1".

I've new bushes that are slightly too tight on the pin, can you use an abrasive to relieve high spots in the bronze bush ( I realise the danger of making them out of round). Will sharp particals be embeded in the bronze? I don't have a reamer & I think the ends have closed up very slightly...

To bench test a 'piggy back' ECU for compatibility, it would be helpfull if no fuel is needed to be run through the injectors. Will the injectors overheat/be damaged doing this? thanks

Thanks for the info'!

I assume it would help to use a drop of loctite when pressing in new little end bushes?, the bushes are a tight fit-it carn't do any harm? thanks

Found some, thanks

Yes I've looked, carn't get the grade I want. thanks

Can any one tell me where I can get some CA954 bar stock from in the UK?, I nedd about 4''x 1"OD, thanks

I've called the Leeds company- they only do quantity orders, thanks. Its for a turbo bike engine (not car sorry),Suzuki GSXR1000 K6, useing K3 rods which have a bigger piston pin, the bush needs to be 18mm O'D' x 15mm I'D', width about 10+mm , x four, I would want to ream the bush once...

I'm after some high strength small end/ wrist pin bronze bushes, after hours on the net still carn't find what I need, any suggestions? ( US or UK ) thanks

I all ready have a wideband gauge,do you need a data logger to build a map? looking at the gauge only whilst driving, I quess it's easy not to see a lean out?