I have seen others similar to these for sale before but don't recall the price. I'm not sure what would be a fair price. Of course I would like to get a bargain but not sure what to offer. Do you have a price in mind? Thanks
i believe fran is correct regarding driving 500hp to its full capability rather than 1000hp to 50%. thats why i am going to take driving lessons. i'm going from 200hp to 700hp. i want to be smart.
dale in okla
What a great looking car. The attention to detail is obvious. Those wheels fit nice & tight under the fenders. You should be very proud of this build.
dale in okla
OK - I'm going to post this knowing I'm going to catch hell. The last car I had with your symptom. Start when cold & will not start when hot suffered from low compression. When the car was hot everything expands & the engine wouldn't start. The engine does turn faster when push started...
Julian - You have done a wonderfull restoration. It's very rare for anyone to start a project such as yours & follow thru to completion. The GT40 crowd seem to be a cut above most other builders. The best compliment I can give is ( ATA BOY). Thats oilfield roughneck slang for good job...
Man I like the looks of this Kinsler setup. I'm in the process of purchasing a World Products LS7 & I obviously want something exotic. I want my cake & eat it too!! I have been considering a Hilborn Injection & converting it to EFI. I want 650 HP & 30 MPG. I have owned & rebuilt several...
I also have a set of Mark's light covers. My covers needed to be about an inch longer at the front & Mark fabricated a set for me. They have an extremely clear luster & I would say look better than a factory built cover. They are very flexible. I used extreme caution while trimming &...
Ron - I have been planning on supporting the forum for a while but have procrastinated. Offering the crystal slammed me over the edge. I collect crystal anyway so sign me up. Its very generous of you to make this offer.
Thanks
Dale in Okla.
I have read this forum for a couple of years but did not join until recently. This is my first post but couldn't hold back. I don't blame Russ for raising hell about the quality of the ARE sump. It truly looks like garbage. Altough any manufacturer can have an occasional problem this is not...
James have you sold rear body panel yet & does it have wide fender flares? Its difficult for me to tell. What other parts do you have available? I would like to purchase body latches if priced reasonable. My car is scratch build & I'm close to completion.
Dale in Okla