Recent content by Sean Tinnell

Those are just the natural, not enhanced curves

It’s taken some time but I’ve been hard at it on reassembly and am just about there…

PM Sent

I like the keep it simple stupid approach. I had the driver side tank modified to install an in tank aeromotive pump with its own reservoir and check valves ( eliminates the need for a swirl pot or other type of external reservoir of fuel). The passenger side tank simply has a low pressure...

Thank you Dave, I’m definitely planning on doing some protective film. I made the mistake of not doing it on my cobra and that won’t happen again.

They are painted

Stripes are on…

Well it's been a long wait, but I can finally see the light on the other side of the tunnel. The car went to paint in April of last year, it took a while to get it done because there were other projects in front of it that had delays, which in turn slowed down the progress on my car. I'm very...

Nah mine has a gap as well. It was needed to make the spider match the height of the front clip.

Phil, could you snap a couple of the seal you have at the bottom of the spider as well?

Thanks Phil, I appreciate the info.

Chet, mine seems to work just fine, I installed it per the manual. My driveway is fairly steep and it holds the car very well. I’ve never had any issues with it hanging up either. Unknown on the long term effects because the car has only been driven short distances.

Phil, I noticed that you have locking pins on the rear clam? What made you decide to add them? I thought they might be needed but RCR told me they don’t

Phil, It's going to be a blue not sure on which one yet. My painter is going to spray out a few samples that I've narrowed it down to.

It's been quite some time since I've posted an update, so I'd like to fill everyone in on my progress. I've still been chugging along on the build, just slowed down a little. The front end bodywork got finished up, so I gave my painter the rear clip to start body working. Both doors are on...