Recent content by stevenx40

It was my first kit car when i was 18 , many configurations, 3 paint schemes. I had a corvette motor and always had heat problems, motor wise and cabin and broken transaxle parts. Last iteration before i sold it , cut open the roof and put a Turbo 350 trans. Depending on your skill set and...

Hello, I have it running over a year with no problems but I do have it installed between the return side of the heater core and return line of the radiator. The temps never reach 175 because of the water temp drop through the core. Steve

Hello, I had the same issue even with the angled feed fittings in the main lines, added the attached electric pump 5/8" inlet and outlet no need for adapters and this shutoff valve.

Sold

Hello, I have a pair of the lower front fender badges for sale , bought them many years ago believe them to be reproductions never used. $75.00 for the pair free shipping in the USA, elsewhere will have to be determined. Steve

I ordered a RCR Jag xj13 in May of 2018 and picked it up in July of 2019 all parts except the steering rack. 27 months latter the rack arrives but is not what i was expecting. Pictures below 1) original SCF rack 2) another from a RCR kit 5 years ago 3) what i received I am no expert...

Joke

I agree with Dave, I would not purchase any production or especially a replica vehicle as an investment. I think we all would like to believe and hope that we could recoup a big part of the dollars invested in our interest but ! ! Unless you have a irrefutable crystal ball that will guide you...

Hello Barry, I believe that is the Fiberfab GT15 model, lots and lots and lots of work ahead . Steve

This may help for the Trans side

Adrian, Your inbox is full and not excepting. Can you make up two with the wings brazed at 90 degrees to the original slot and fill in slot with braze material and left in a unfinished state that I will finish. Your size and shape are close enough to my originals. Give me a total...

Try going to Level 10 Performance Transmission Systems Bulletproof Transmissions,Supercharger They make just the controller you are looking for and reasonable. The 5HP19FL would be an excellent choice for a modestly powered road car !!

What is your car using for this design ? I have two 3/4" ball joint rod ends that the main upper shaft passes through and is supported but I don't like the metal to metal contact. Steve

I have just finished ordering my A/c lines and fittings from Vintage Air to complete my system. I will be using the beadlock fittings. I have twelve crimps that need to be made and the tool they sell cost over $450. Does anybody have any suggestions for alternatives or a tool they might be...