Search results

Presuming its the G96/50 or turbo then 4litres of GL5 75/90 (synthetic)--maybe add an oil stabiliser if you're going to be fangin' it

PM me ---I may be willing to offer info --pending what you are prepared to offer

Well done Bill, the car looks fabulous

Corvette C5 wheel hub to 930 CV stub shaft -- from billet 4340 steel and heat treated or a modified C5 universal stub -- some 20 years ago for under $500.00 aud each -- feed back said too expensive, therefore ceased production

I found these guys really helpful --- as you would imagine --off road stuff takes a floggin' Rear Suspension VW Parts

Holden commodore VS (short ones) drive shafts should fit -- you'll need the CV stub shaft at the wheel hub

7 10ths focused on finishing ;-) Facebook

We did our first enduro, w'end gone so --we stuffed as much fuel into the tank as it would take ( turns out to be ~50 something litres) and hope for the best -- the race duration was to be 50 mins with a 45 sec pitstop/ or driver change Most elements were covered -- dodging crash damage , oil...

A fan sent this pic

Reset my PB at Queensland Raceway-- car performed flawlessly -- didn't have to fiddle with anything except for adding fuel Facebook QRDC Rnd 2 Race 3 opening lap C6 Corvette Greg Quince - YouTube

Very interesting -- do you have a pic of the stub shaft ? --and can you identify the origin of manufacture of the hub bearing ? ( I know the Chinese bearings are prone to failure)

Pretty sure the splines are 27 for GM stuff and 28 for Ford

Just replaced broken upper A arm heim joint and steering arm bolts --a quick wheel alignment, nose back on and all good to go, finishing the last races Some cracked fibreglass repairs needed -- the radiator dodged a bullet again thankfully and no noticeable fire damage

There was an incident for the first race of the season unfortunately! Trapnell Creations Photography | Formula and racing pic 100 page 9

Well! I do like to read about all these strokerisms --been there and done that and now with my basic mild performing 302W I know that by travelling on a highway at the speed limit for say, 100 miles I will get there at exactly the same time as a megadollar motor -- a bit cheaper on fuel and...

Tx Johan :thumbsup: Hoosier R7 30 psi hot -- 275 50 15 and 225 50 15 -- Avons to try this year "granpa" is looking good --obviously spent more money on paint than I did

Hey Rod - had a couple weeks in the US recently centred around Ottumwa and Albia --touch down cedar rapids , exit Des Moines . -28°C was a bit of shock treatment tho as we're used to +30/40°C atmo Ross McComb (Quick time bellhousings etc) was our host and he took care of us like long lost...

Flywheel, clutch, ringear --this is the system that we use which works for us --anything else , you're on your own

This is what we use with a "high torque" type starter