Search results

Make sure the inverter is in place when you give power to the circuit. If the fans don't come on try switching the non ground connections on the inverter. Every time that the fans didn't work it was because the power feed connection was put into the wrong side of the inverter. I've never...

First the blue with yellow wire has to be put into the master cell main connector. That same wire is connected to the GM fan output. If the fans aren't coming on it is possible that Infinity Box put the inverter on incorrectly. (I've seen that a few times) You can disconnect the wire back at...

The tach signal should be fine but each gauge usually has its own sensor.

I find the best way to deal with them is when I put the first coat of high build primer. At that point you can fill them with 2 part spot putty or if they are really small with the high build primer. One method is to use a very small paint brush and force the primer into the pin hole, over...

They are M12x1.5

Move the brace that connects to the splitter as close to the edge of the splitter as possible then the fender well will fit in behind it. Just make sure that the brace doesn't hit the tire while turning.

I have a Graziano now that just got back to me with drop gears. Just had the first start so I have not driven it yet. It is a about a ten hour job to get the gears in. They are deep inside there and involve much more than taking the end cap off. The end cap and main casing have to be...

The defroster vent is only open on the driver's side. I never had an issue with the windshield fogging up. I know of other builders that just put never fog on the windshield. The Alsa soft feel paint does come out nicely. If you use it just make sure that it fully flashes before applying...

Yes it does, they have a matching bracket, TB2, that allows the seat to sit at its lowest position.

Thanks everyone, I more incredibly happy with my GT-R.

On the paint booth, downdraft or semi downdrafts work best. Adjustable fan speed really helps. Make sure they have good lighting. Booth heater isn't necessary especially in warmer areas but can help especially with water base paints. When painting you have to have a water and oil remover and...

Thanks everyone, soon I'll get one of it driving .

Thanks, funny, my friends make fun of me for sleeping so much...

Thanks

Here's an overview of my Superlite GT-R licensed and ready for driving. I have been working on it since May of this year and just the interior needs finishing. https://www.youtube.com/watch?v=k2LIcWktSdE

Here's an overview of my Superlite GT-R licensed and ready for driving. https://www.youtube.com/watch?v=k2LIcWktSdE

cts-v is the same, as long as you are using a GM harness.

Record the error log and email it to Jay at Infinity Power. He will let you know what is happening.

Error Log Check the error log on the master cell. Also check the connectors on the CAN lines to make sure that the inner pins can't push out of their retainer when you plug it in.

The front has wheel adapters, the manufacturer will be making hub centric spacers.