Search results

Got steering pretty close. Ready for alignment. Brakes aren’t right. Put in Wilwood valves and re bled them. Still can’t lock them up with a hard push. Will need suggestions. Going to check for leaks, but pedal feels good.

Voice to text. And hitting post before reviewing.

One of the things I wanted to knock out today was my reverse lights not working. I started tracing it from the tail light itself up into the dash. There are Sauter’s between the output of the light to a wire another Sauter to the transmission switch on each side of the switch and an additional...

I am going to run 19F/20R on my GT-R.

Got rear half shafts, wheel studs done and back together. Installed remote solenoid kill switch in dash. Bled and adjusted ram lift. Have to fix steering like H said. Back on too of upright. Will need to set ride height so I can turn without interference on rim to adjuster sleeve. Reverse...

Ive done wheel studs in a press and once even tried to press the wrong size knurl. Bent a hub. This is a learned behavior.

A little grease on the stud, a little on the hub. Great tool.

I noticed that from Daily as well. -16 for the big stuff, -12 for the rest. But the fitting that comes out of the block on mine is a -10. So no matter what, one leg is going to be the bottle neck.

They come with new clamps but I like ss zip ties over the square hat tie that needs special tool.

8 tubes of driveshaft shop grease. Size of medium toothpaste. Black grease. Will post pics after my Zoom meeting in 3-2-1.....

3 day weekend. Plans: Bleed Ramlift, replaced plugs with WIL-220-0063 Brake Bleeder Screws, Repair Kit, 1/8-27 NPT Thread, Front/Rear, Universal, Each (Mfr. #: 220-0063) check that front suspension is tight, torque everything that doesn't get undone with corner balance and alignment...

I put them back on top. Will use smaller spacers to get them as low as possible, set ride height lower, and should not rub. Thanks. Coming back to you soon....my H-list is growing.

Graziano axle boots are same for inners and outers. BT -367 Replacements at driveshaft shop are $31. So how did I rip the right side completely apart in 14mi? Ugh. In other news, going to try a third turn signal/hazard combo to go with my Speedway harness kit. This one is from Speedway...

Great news: Motor is fine. And hold 15 qts of oil. I have the 3 extra qts on my garage floor. Was leaking out the fill cap on my Peterson 3 gallon tank. Oh well. Got to re-bleed clutch and reset the linkage. Adjusted steering at uprights as it was hitting the rim at full turn. Lowered...

Thanks. The replacement is stainless braided over the rubber. All of the hoses are pressure rated for far more than an oil, fuel, or coolant system needs. But I did buy a pre-assembled 48" -10 hose from Summit as the replacement.