Search results

Hi I'm currently getting quotes from several suppliers but thought I'd check here as well. As the title states I'm looking for a right hand drive dash. Condition is not critical as I will be cutting and modifying to suit my scratch-build anyway (it's several inches narrower at the A-pillars)...

I have a pair of the Stewart Warner 240A pumps for my project and have a couple of quick questions. How were they grounded on the original GT40s that used them, from examining various photos I can't seem to see? Is it a wire or a ground strap, and where on the pumps were they attached? In...

Gentlemen, I just picked up this old cast aluminum small-block oil pan and was wondering if anyone has any idea what it came off of? The seller believed it was a marine application (Holman Moody or Chris Craft) but wasn't sure. No casting numbers except "1001" and "510" cast in the left rail...

Hi, since my scratch-built is going to get a whole new chassis built, I've been considering switching it to RHD. Currently it uses the Mustang II type suspension including the rack. I have access to a 3rd gen. RX7 RHD rack for free, is this a decent rack to start with and as it's a power rack...

As originals use the SW electric fuel pumps, did they use a block-off plate on the front cover for the mechanical pump or was there a unique front cover without the pump opening? I'm trying to be as "correct" as I can with my build and I'm curious if a standard '66 289 front cover is right? (I...

I have a Smiths 200mph speedometer for my project and I'm curious as to what others have used in terms of cables. I'm using the Audi 016 gearbox and have a new cable for it but obviously it's far too short and doesn't have the correct size end for the speedo. Are there connectors available or...

I'm in the process of getting a flywheel adapted to work with an Audi 016 and both my machinist and I are not confident on the amount of compression is required when bolting the clutch on. Anyone know the distance between the clutch mounting surface and flywheel before it is tourqued down? The...

Greetings to all, first post of many to follow on my scratch-built GT40ish project. A GT40 has always been an unatainable dream, even the kit costs have been out of my budget. This all changed when I came across an advertisment for a "66 Ford GT" From the photos and the price I knew it wasn't...

Hi, I've started collecting parts for my scratch-built alloy GT, and find I need to sort out my flywheel/clutch before I can proceed with re-building the chassis. (I had hoped the smaller Mustang II flywheel would work as I have several but afraid it's just a wee bit to large for the Audi 016)...

Hi everyone, I'm new to this forum and the GT40 community as a whole..that is until a week ago when I purchased a "garage queen" listed on a local classified site. Now I'm hooked:thumbsup: I'm employed as an industrial painter for a fabrication shop (oilfield equipment) so fortunately I have...