Davidmgbv8
Supporter
Does anyone have a drawing of a "turkey Pan" heat shield for a 4bbl carb, 302 engine. I would like to get one to my water jet guy to have him cut for me to bend one up.
4 BBL Carburetor Turkey Pan
- Thread starter davidmgbv8
- Start date
Ian Anderson
Lifetime Supporter
Hi David
it will all depend on many things, engine mount height, gearbox mount height, angle engine finally sits at, inlet manifold etc as the Turkey pan sides need to seal up against the underside of the rear clip to stop the hot air getting to the carb
Ian
it will all depend on many things, engine mount height, gearbox mount height, angle engine finally sits at, inlet manifold etc as the Turkey pan sides need to seal up against the underside of the rear clip to stop the hot air getting to the carb
Ian
Last edited:
Davidmgbv8
Supporter
ahh good points.
