What are the fitting size for graziano for clutch and trans cooler
Graziano fittings
- Thread starter kelly galloway
- Start date
Ken Roberts
Supporter
Trans cooler- M16x1.5 https://www.pegasusautoracing.com/productdetails.asp?RecID=4209
Clutch- M12x1.5 https://www.pegasusautoracing.com/productdetails.asp?RecID=12102
Also you need a crush washer for each trans cooler fitting and a 1/8" npt x3AN fitting for the clutch line.
I originally tried a banjo bolt and fitting for the clutch but found the orifice size too restricting.
Clutch- M12x1.5 https://www.pegasusautoracing.com/productdetails.asp?RecID=12102
Also you need a crush washer for each trans cooler fitting and a 1/8" npt x3AN fitting for the clutch line.
I originally tried a banjo bolt and fitting for the clutch but found the orifice size too restricting.
Last edited:
Stephan E.
Supporter
Hi Kelly,
All plugs have the threat size on it.
Cooler in/out M16 x 1.5 with crush washer
Bottom clutch connection is M12 x 1.5 with crush washer
Top Clutch connection is M14 x 1.5 with crush washer
Stephan
Thanks a little bit confused. Upper and lower clutch I thought lower plug for clutch is upper for bleeder. Thanks I just don't want to screw anything up.
Stephan E.
Supporter
Some use the upper. You can still bleed it, just not as easy. I use the lower. Looks better.
