Alex Hirsbrunner
Lifetime Supporter
Hi Folks,
I came across four of these plates while unpacking the RCR which I assume are for reinforcing the rear mounts where the body attaches to/pivots on the rear extension (based on a similar shape I noticed in one of the photo's Ron McCall posted in his build thread). I have four of these and they are each 1/4" thick.
If they are for the rear pivots, are you using 2 per side (that's a 1/2" of plate!) to sandwich the mounting point? and did you bond them to the frp (e.g. with 3M duramix) or just use fasteners to mechanically clamp it?
Thanks,
Al
I came across four of these plates while unpacking the RCR which I assume are for reinforcing the rear mounts where the body attaches to/pivots on the rear extension (based on a similar shape I noticed in one of the photo's Ron McCall posted in his build thread). I have four of these and they are each 1/4" thick.
If they are for the rear pivots, are you using 2 per side (that's a 1/2" of plate!) to sandwich the mounting point? and did you bond them to the frp (e.g. with 3M duramix) or just use fasteners to mechanically clamp it?
Thanks,
Al