I noticed when I received all of the dyno data printouts from KC some runs went down lower in RPM. Have you received all of the data?
The numbers just in...
- Thread starter Sandy
- Start date
That is because the software for the dyno only record or presents them with the data starting at PEAK torque. So I would expect that the early peak torque on the big motor is the result of that. I think it is probabally something they just need to change in their setup. They said everyone complains about it... Go figure why they have not fixed it.
Sandy
Sandy
See RCR forum for pics of this killer engine...arrived yesterday....
I finally get to see it!
And Gary, I didn't read the last post correctly. Yes I had a couple of other runs that went down to about 6000 I think but I am guessing that they were doing jetting and a bit of timming which had peak TQ at lower then the run that was the final. Needs to be fixed on KCR's end.
Sandy
And Gary, I didn't read the last post correctly. Yes I had a couple of other runs that went down to about 6000 I think but I am guessing that they were doing jetting and a bit of timming which had peak TQ at lower then the run that was the final. Needs to be fixed on KCR's end.
Sandy