Its official MK I GT40P 2426

Rob Klein

Supporter
It's been a long wait but its over.

MK I GT 40 Tribute package
Screen Shot 2021-05-04 at 6.16.13 PM.png
 
One of my favorite schemes. I vacillate between this scheme and P1061... the MK1 Gulf configuration has the best rear end hands down (IMO)
 
Just curious, when did you place your original order, and when did your build start?
I placed an order for P2442 which has a build date of July 2022. Sounds like the build has been going on for several months. Will be interested to see how long this process takes, including the build, shipping to destination, and the engine/transaxle installation. Who is going to do the completion of that beast?
 

Rob Klein

Supporter
4/26/21 is when I signed my order and sent my deposit. Currently my car is in final inspection, and I hope to get photo's in the next couple weeks.

Once the car is on the water, it takes about 30 days to get to Olthoff, then about five weeks for the build.

My motor will be finished in the next couple weeks, and sent to Olthoff.

My build might take longer because I am going to rinse the superformance details, and do more of a race car interior.

I was told the factory builds two GT 40's per month.
 
4/26/21 is when I signed my order and sent my deposit. Currently my car is in final inspection, and I hope to get photo's in the next couple weeks.

Once the car is on the water, it takes about 30 days to get to Olthoff, then about five weeks for the build.

My motor will be finished in the next couple weeks, and sent to Olthoff.

My build might take longer because I am going to rinse the superformance details, and do more of a race car interior.

I was told the factory builds two GT 40's per month.
Can you provide some details on the engine (make,size etc.)?
Thanks,

/s/ Chris Kennedy
 

Rob Klein

Supporter
Finally got the pictures
 

Attachments

  • Screen Shot 2021-12-15 at 4.07.53 AM.png
    Screen Shot 2021-12-15 at 4.07.53 AM.png
    1.2 MB · Views: 488
  • Screen Shot 2021-12-15 at 4.07.31 AM.png
    Screen Shot 2021-12-15 at 4.07.31 AM.png
    1.2 MB · Views: 476
  • Screen Shot 2021-12-15 at 4.07.17 AM.png
    Screen Shot 2021-12-15 at 4.07.17 AM.png
    705.3 KB · Views: 481
  • Screen Shot 2021-12-15 at 4.07.03 AM.png
    Screen Shot 2021-12-15 at 4.07.03 AM.png
    1.2 MB · Views: 487
  • Screen Shot 2021-12-15 at 4.06.48 AM.png
    Screen Shot 2021-12-15 at 4.06.48 AM.png
    1.7 MB · Views: 473
Thank you---is this one of the Shelby blocks and the Borla injection unit? Will you be using an internal hydraulic throwout bearing for the clutch activation or an external slave cylinder/lever set-up?

/s/ Chris Kennedy
 
Back
Top