Udo
How did you fix you spigot bearing adaptor problem.
Iv gt the same length issues, its 5-10mm too short so i expect the same will occur.
Did you just get a longer one made up?
Karel
Did you made the bolts holding the lower rear suspension arm captive. If i bolt the bracket back on id just loose all the width gained in cutting the box section down by half. Did you tape a thread and use shorter bolts, im considering doing this ad welding the bracket on as well
Just...
Unfortunately i wont be there. If uoi get chance an manage to take a pic of how your box sits against the chassis rail passenger side that would really help.
Udo, do you have any more pics of how your gearbox sits on the chassis on the nearside. Did you have to modify the chassis in any way, mounted my 01x without any modifcation and the engine tilt is too far forwards atm.
Shaun
The bars position depends of which cables you get. Talk to speedy cables, thats where mick got them mode, i paid £100 delivered for a pair. You need to let them know the type of handbrake caliper's you're using so they fit the right end. They have drawings for the cables mick used to have...
I'm struggling to find any useful pictures on peoples build treads on how the SGT handbrake bar bits, and how the cables are fitted at the handbrake ends.
Handbrake handle and rods are fitted. I'v got the cable holding bar ready to go in and finally the cables have arrived so any advise or...
Lee, information seems to be thin on the ground, i'v tracked down where they came from but even then theres little to go on.
I have read that moving the bulb round can change the optics.
https://ayfar.com/en/urunler/36-12-tl-12ts-headlight/
You fitted LHD units.
I got some renault 12 units but now been informed they are for LHD. Wondering if i'll still be able to use them, can i not just turn them upside down
Ben, in the end i just bit the bullet, blew the budget and ordered a flywheel, clutch, starter etc from gt racing. Only thing i didnt was the adaptor you made for me and spiggot adaptor
No worries, that does contradict the email conversation i had with ak only a couple of weeks ago. I guess time will tell when they finally publish a price list. Lets all hope any increases are small.
I hope AK keep there prices sensible but initial contact with them over parts makes me think there going to jump up considerably from Micks prices. Might regret not ordering more parks before the switch.