Hi,Don great build thread I also would like to only have one fill spout on my Mkiv car.I will probably run a crossover line from one tank to the other tank , can you explain how your electric truck valve will work .
Thanks wayne
Hi,all good points but me point is when you touch ss pipe the ss pipe is 10 degrees cooler than hushmat,also tried hushmat on tunnel where coolant tubes go threw and hushmat is 10 degrees hotter small piece of foam same temp as tunnel.If hushmat is used on fire wall may increase temp
What ever you do ,do not wrap your coolant pipes with with hushmat.hushmat raised the temp 10 degrees higher than ss pipe.
Howard are you going to glue neoprene to pipes?
Thanks Wayne
Thanks for the post .bill what size are your mufflers? I had a set of magnaflows on my truck took off to deep sounding but thought they might sound good on mkiv but they do not have the size i need.
Thanks wayne
http:/supercharged mkiv gt40 HI STARTED ENGINE ,DOES NOT SOUND RIGHT.ALSO STILL TUNING ENGINE.I WOULD LIKE ANOTHER SET OF MUFFLERS SOMETHING DEEPER ANY SUGGESTIONS?
MUFFLERS HAVE TO BE 4"TUBE (BODY)16" LONG 3"INLET AND 3"OUTLET.
THANKS WAYNE
Chuck
thanks for response,summit says sponge could hit fuel sending unit they said i need a special sending unit witch unit did you use?also how did you vent your new tanks?
Thanks wayne
Chuck
are you still using the holley 125 fuel pump with new rcr fuel tanks?
Holley says pumps need to be mounted below fuel tank if so how does the fuel pump draw fuel from the gas tank,is your fuel pump above your fuel tank?also does your fuel tanks have baffles mine does not do i need baffles...
Bob that is what i am concerned about also i was already going to rubber mount radiator ,will modify frame so when frame flexes it will not flex radiator.